Spa concrete slab installation
- Make provisions for a reinforced concrete slab 75 to 100 mm (3 to 4 inches) thick.
- Connect the ground lead to the wire mesh.
If the spa is being installed on an existing patio or deck, the patio or deck must be level. Make sure the patio is structurally sound, and able to support the weight of the spa, water and occupants; talk to a structural engineer.
If the spa is being installed on crushed rock, remove grass to 6 inches beyond the sides of the spa and fill the space with crushed rock. Make sure this base is level and well compacted.
Make sure mechanical components (motor, water heater, etc.) are easily accessible. Provide extras for maintenance if your spa is not accessible.
ElectricityHave a licensed electrician hook up your spa and make sure it is GFCI-protected.
Did you know?
Looking to solve your pool or hot tub water challenges at the snap of a finger? Sneak a peek at the “Water Analysis” section of our “Tips and Advice” section for all you need to know to maintain well-balanced water. Or, come meet our specialists who will be happy to help!